
Bộ điều chỉnh độ rơ (Bite Point/Preload) cho Magura MT5
- Downloads
- 0
- Likes
- 1
- Views
- 31
- Remixes
- 0
- Comments
- 0
Files 3 162.8 KB
- Hose_clamp_1784363479.stlSTL · 47.3 KB
- Brake_lever_clip_1784363480.stlSTL · 62 KB
- Bite_point_adjuster_print_2x_1784363481.3mf3MF · 53.4 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #413602
- Category
- Dụng Cụ Tiện Ích
- Published
Description
This mod only works with the MT5. I designed it after realizing that no one had made one before, and I didn't want to spend money on two expensive levers just to get the preload adjustment on my brake.
This mod is designed for the 2-finger lever. I haven't been able to test it with any other lever type, so compatibility with other versions is unknown.
If you're on a budget or simply don't want to spend around $70 on new levers, you can use super glue to attach this mod.
Installation
-
Slide off the strain relief, or install the brake without it. (This might not be the best idea. If I find that it causes any issues or damages the brake, I'll update the description with a warning.)
-
Clip the hose clamp onto the brake hose and slide it over the metal fitting at the end of the hose.
-
Rough up the plastic surface at the end of the brake lever to help the glue bond better.
-
Apply super glue to the brake lever clip and attach it to the lever.
-
Screw an M3×20 mm screw into the hole in the brake lever clip.
-
Adjust the bite point to your preference.
Material
- PETG
Hardware
- 2 × M3×20 mm screws
If you run into any problems with this model, let me know and I'll do my best to fix them.
Print spec
- Formats
- 3mfstl
- Model files
- 3
- Total size
- 162.8 KB
- Largest file
- 62 KB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-

-


