Skip to main content
F3D
Lee Challenger Right-Side Case Kicker v1 - Bộ đẩy vỏ đạn bê… 1

5 images

DIY

Lee Challenger Right-Side Case Kicker v1 - Bộ đẩy vỏ đạn bên phải

By carlcarl_1612899

Downloads
12
Likes
3
Views
84

Files 7 849.6 KB

  • primer_ramp_1783851255.stlSTL · 64.5 KB
  • foot_m3_screw_1783851256.stlSTL · 76.8 KB
  • mount_m3_screw_1783851257.stlSTL · 223.6 KB
  • kicker_m3_screw_1783851257.stlSTL · 92.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Case Kicker that ejects to the right, and kicks at the end of travel to allow for longer cartridges. Interacts with the Press handlebar, so the handlebar must be completely vertical when in the up position. Decapping Primer ramp included, as the Lee primer arm will cause the case to bind.

Case kickers speed up the process and quality of life for the reloader. My setup requires case access from the right, all the other kickers load/eject to the left. Figured others could use this too.

Two versions included. 3mm screw and #6 screw.

Hardware needed:

  • Zip Ties

  • Rubber band

  • M3x+20mm screw or #6 x +3/4" screw.

Instructions:

Screw the kicker, mount, and foot together. Ziptie the mount to the left side of the press' front column. Loop rubber band around front notch on kicker, then feed the rubberband around the front of the column and around it to the back, feed UNDER the kicker and attach to the rear peg of the mount. See pictures.

Print settings:

  • Filament: PLA/PETG/ASA/PA

  • 3 perimeters

  • 30% infill

Troubleshooting: If the kicker binds on the ram, slide the mount higher up the column.

Read more Show less

Print spec

Formats
stl
Model files
7
Total size
849.6 KB
Largest file
223.6 KB

0 comments

See all