Dụng cụ cân bằng chậu cây Planter Horizontalizer

This is an asjustable distancing peg, large diameter and low threadcount with high tolerances means you don't need extremally dialed in printer to make it.

When your planter hangs on a railing skewed, all the water will pool on the side, which is even worse if your planter was designed with a reservoir. This contraption solves that problem by adding another leaining point. WARNING, this is a two persons job - it usually needs two pegs to comfortably sit horizontally and not sway in the wind, it's very difficult to keep dozens kilos of dirt away and unscrew the distancer at the same time.

 I've also attatched a scad file, it relies on BOSL2 library, which is open source and you can download it from the authors. I've used AI to adjust some thread properties, so you may found some funny sounding comments in the code.