Bộ đầu nối PTFE cho Creality Space Pi X4 - PC4-M6

Printed fittings to use with the Creality Space Pi X4 and PC4-M6 fittings that prevent PTFE tubes sliding in to the standard ports and getting wrapped around your filament spool. Because the PC4-M6 fitting butts up to the printed part, feeding filament out to your PTFE tube is smooth and easy.

Three sizes are included, one for the front ports and two for the rear, the longer one penetrates through the rear port, the shorter one is flush with the back of the unit (shown in the photos).

I printed mine in ABS at a 0.15mm layer height and the M6 threads work well.

Pop out the support with some tweezers and then run a 2mm drill bit through the hole to clean it up.

To remove them, just slide some tweezers between the stock fitting the printed part and pull it out.