Bộ chuyển đổi MGN9H sang MGN12H

Print Settings

• Choose a filament that meets the temperature and strength needs of the adapter.  I chose ASA GF.  

• Infill: 40% Adaptive Cubic.  This is not critical and is somewhat dependent on the application.

• It is recommended to use 100% infill around the M3 bolt holes.  It is not critical, but gives the bolts a firmer surface to mount against.

• Wall: 5 lines

Adapter Installation

Parts Required:

• M3 T-Nut

• M3x8 Cap head bolt

Assembly Instructions:

1. Tighten the adapter to the linear rail by inserting the tightening the M3x8 bolts.

2. M3 T-Nuts are slid in over the M3 x 6 bolts to fasten an MGN12H attachment to the linear rail.

3. Attach the MGN12H component

Belt Attachment Installation

Parts Required:

• M3 heat set inserts

• GT2 9mm belt

Assembly Instructions:

1. Install the heat set inserts in to the 2 holes on the side of the adapter

2. Fasten the belt to the front of the belt attachment

3. for the 2 attachments points in the back, wrap the belt around an M3 screw and fold the belt on itself.

Note: I am an Amazon Affiliate and may make a commission from products purchased from the links in this post.