Miếng đệm thay thế cho kẹp Smallrig Crab Clamp

This is a replacement pad for a Smallrig crab clamp  with 1.4Inch and 3.8Inch Thread: 2058 designed to print with TPU 95a. Its a bit trickier than PLA and needs drying and tests for temperature. My settings with a Bambu a1 were as follows:

Generic TPU + following changes

Nozzle temperature= min 210 Max 230

Cool plate Initial layer 35. other layers 60

Nozzle Initial layer 230 Other layers 240

Max Volumetric speed 7.2

Wall loops 3

I also slowed the speeds down to 25-30

I still had a little issue with stringing but i think that was the temperature and humidity in the room. 

They pads fit very well and work perfectly.