Đế giữ điện thoại SUPER simple

15-Minute Pocket-Sized Phone Stand!

Tired of bulky, overengineered phone holders that take hours to print? This design brings you maximum utility in the most minimalist form possible.

It's ultra-compact, lightweight, and perfect to throw in your pocket or bag. Best of all? It takes only 15 minutes to print on standard settings.

features

• Ultra-Minimalist & Pocket-Sized: Takes up zero desk space and goes wherever you go.

• Lightning-Fast Print: Print it in just 15 minutes. No more wasting hours of print time!

• Simple & Reliable: No complex mechanisms, no moving parts to break. Designed to print clean without any hassle.

• Spool Saver / Quick Gift: Perfect for using up those last few meters of filament on your spool, or making a quick, practical gift for friends.

Print Settings:

• Supports: No (need  support  for star version)

• Infill: 15% - 20% is more than enough for a sturdy hold.

• Layer Height: 0.2mm (or 0.28mm if you want to push it even faster!)

Quick Tip: Make sure your bed adhesion is on point since this is a small model. A well-leveled bed is all you need!

This is the perfect quick gift for friends or coworkers who always prop their phones up against coffee mugs or books