
Tay Cầm Kéo Dây Dù (Paracord Drag Handle)
- Downloads
- 7
- Likes
- 2
- Views
- 34
- Remixes
- 0
- Comments
- 0
Files 1 1.8 MB
- 550_Handle_1783583531.stlSTL · 1.8 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #409060
- Category
- Thể Thao & Ngoài Trời
- Published
- License
- Creative Commons — Attribution
Description
A friend gave me an old kayak and it's drag handles were long gone. So, naturally, I designed one to use 550 cord with. Could be used for whatever you need to attach a handle to I suppose.
The back end of the handle is recessed so the knots fall into it somewhat flush. The holes are 5mm diameter. 550 cord passes through with a little coercion. I'm sure other ropes or cords of similar diameter would do just fine.
I printed mine out of PETCF, just make sure to use something higher temperature than PLA if its going to see regular sun. Moderate infill density should be fine, I used 20% 3d honeycomb and top surface ironing for a nice finish.
Just pass one end of your cord through the front and knot it. Set the length of your cord loop and pass the other end through the front and knot it as well. Remember to burn the ends to prevent fraying then pull it tightly into the handle. The conical chamfer will jam the knot tight.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 1.8 MB
- Largest file
- 1.8 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-

-


