Giá gắn khóa Kryptonite Evolution Mini-7 cho Segway Ninebot Max G3

The Ninebot Max G3 comes with mounting points for a supplementary battery, but I decided that a better use for these is to hold my Kryptonite Evolution Mini-7 lock.

Features (that differ from the original)

• Slit for the key to be left in the hole when the lock is mounted to the holder

• Fits a different (smaller but longer) lock

• Slightly less bulky

• When mounted, the lock squeezes the holder to sit firmly without rattle

Recommended to print as oriented in the STL i.e. lying on the right side for strength as this part will be subject to a lot of stress (part of the design is that the holder is slightly too tight, so as to create a snug fit and avoid rattle).

Note: This version that's uploaded now is about 0.2mm too short to avoid rattle, I didn't want to upload an untested STL so my recommendation is to add 1-2 strips of electricians tape to the bottom part to make the fit even more snug, which also doubles as extra vibration dampening which is nice. If you're feeling brave, open the design in Fusion 360, add something like 0.1-0.3mm to the lock_u_length parameter and use that when printing (remember to reorient and print it on its side). Please post a make if you do and I'll update the model here!

I printed using Prusament PETG, "0.20mm STRUCTURAL" preset with 40% Gyroid infill and 4 perimeters, with supports added to the bar.

Design file

For some reason Printables won't accept the f3d file (it says "That compression method is not supported") so here it is shared through Proton Drive for the time being: https://drive.proton.me/urls/Y10D3D5XB8#MVPrNOBo0UYI (I'll upload it properly once I hear back from the support about what's wrong)