Tay ga (Throttle Lever) máy cắt cỏ Murray

This part is designed and toleranced to be printed in ASA. Keep this in mind when downloading and printing!

Replacement throttle lever for my 1990's Murray self propelled push mower. The arm had broken off years ago, but my father was not using this mower anymore. When I inherited it, I took the opportunity to design and print something rather complex from ASA since I had upgraded to a newer, better printer.

Recommended print settings:

• SUPPORTS MUST BE ENABLED!!! I used trees, but normal would work as well.

• Scale: X and Y only 100.70% - This will vary based on your printer and throttle cable housing tolerance.

• Walls: 4

• Infill: 50% 

• Brim: Outer Brim

• Orient with the "tab" in the positive Z orientation.