Cản đẩy (Push bumper) cho Clogs

Off duty? Need to PIT a running suspect? Worried about your dainty toes, or recent pedicure? Worry no more with this Clog push bumper charm! Throw your Crocs into 4 wheel drive and do your thing! This one was designed for the right foot so I included the .stl so you can adjust it for your left if you need backup. I also just uploaded the Left side. I lowered the layer height for detail but it didn't seem to make much of a difference, I turned on Ironing, changed the infill to gyroid at 16% (only because I felt like it),  Support and support ironing enabled,  I change my prime tower to rectangle with a width and volume of 20 (though I doubt the settings make a difference, just saves on waste), Flush into infill (again to save on waste), and everything else I left default. The print time was 4 hours and used 48.06 grams of filament including waste. This is the .3mf and .stl from Snorca so you may need to adjust your settings. I rotated the bumper 45 for the left foot. The only settings I changed from default are as follows: Ironing on, gyroid infill, tree support and ironing support interface on, prime tower rectangle with width and volume 20/20, and flush to infill.  I hope you enjoy it!