Skip to main content
F3D
Cơ cấu thanh trượt limit switch cho lập trình analog 1

4 images

DIY

Cơ cấu thanh trượt limit switch cho lập trình analog

By FabienBlaind_4040512

Likes
2
Views
39

Files 5 180.1 KB

  • Limit_switch_slider_mechanism_for_programming_1782817226.stlSTL · 123.7 KB
  • clicker_arm_1782817227.stlSTL · 9.1 KB
  • threaded_shaft_to_motor_connector_1782817228.stlSTL · 20.6 KB
  • motor_housing_needs_to_be_glued_1782817229.stlSTL · 7.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This mechanism uses an 8mm threaded rod supported on each side by two 16mm outer diameter bearings driven by a small high-torque copper motor (both connected with the provided connector glued on the threaded rod and press fitted on the D-shaft of the motor) to move a clicker arm back and forth along the groove in the main structure. The clicker arm clicks on limit switches placed along the dovetail rails with the use of the limit switch housings. Each limit switch can be precisely positioned and fixed in place with a screw. The motor housing keeps the motor from turning instead of the shaft and must be glued on one end of the mechanism. This system was used paired with relays to allow a complete programmable robot to be driven by timing-based programming, only with no semiconductors.

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
180.1 KB
Largest file
123.7 KB

0 comments

See all