Cần gạt thay thế cho máy pha cà phê Tchibo Cafissimo

This is a replacement capsule press lever for a Tchibo Cafissimo coffee machine.

The original plastic lever (used to press and lock the coffee capsule into place) on my machine broke, making it impossible to properly insert and brew capsules. Since replacement parts are hard to find, I reverse-engineered the broken component by scanning it in 3D and recreating the model for printing.

This part restores the mechanical function of the machine by allowing you to press the capsule down and close the brewing mechanism again.

⚠ Note about scanning accuracy:
Since this model was created using 3D scanning, some geometries are not perfectly accurate. The pivot holes in the model are not exact due to scan interpolation and reconstruction.

• The short pin hole diameter is 5 mm

• The long pin hole diameter is 4 mm

For best results, it is highly recommended to clean/ream these holes with a drill after printing to ensure proper fit and smooth movement.

Printing Recommendations

• Material: PETG or ABS recommended (PLA may wear out faster due to mechanical stress and heat)

• Infill: 40–100%

• Layer height: 0.2 mm

• Print orientation: Place the lever flat for maximum strength along the stress direction