
Chốt giữ nắp Snapmaker U1 - Giải pháp lắp đặt dễ dàng cho thùng IKEA Samla
Remix of Nắp đậy trên cho Snapmaker U1 (Dùng thùng Walmart) By DeSkwared_2962473
- Downloads
- 43
- Likes
- 11
- Views
- 463
- Remixes
- 1
- Comments
- 0
Files 2 68.7 KB
- u1-samla-peg-x4_1782453867.3mf3MF · 43.4 KB
- u1-samla-peg_1782453868.stlSTL · 25.3 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #405406
- Category
- Máy In 3D
- Published
- License
- BSD License
Description
Remove the factory silicone plugs and replace them with these four pegs, positioning their protrusions toward the printer’s centerline. Then place an inverted Samla 45L bin ($7 at IKEA) on top.
Voilà ! With that cover and this five-gram low-profile mount, your Snapmaker U1 is now sufficiently enclosed to retain the heat necessary to print with high-temperature materials like polycarbonate without the warping that comes from cooling too quickly.
This works well for me, resulting in a passively heated chamber of up to 54°C on a 16°C day. Tape over a portion of the vent at the rear if you need to retain even more heat.
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 68.7 KB
- Largest file
- 43.4 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-
New -

-

-

-

-

-



