
HevORT X-Carriage cho Dragon Burner (MGN12H)
- Downloads
- 2
- Likes
- 1
- Views
- 46
- Remixes
- 0
- Comments
- 0
Files 5 397.2 KB
- hevort_x_carriage_main_v2_1782383945.3mf3MF · 125.2 KB
- hevort_x_carriage_back_plate_1782383946.3mf3MF · 118.2 KB
- hevort_x_carriage_BTT-Eddy_mount_1782383947.3mf3MF · 7.3 KB
- hevort_x_carriage_main_1782383948.3mf3MF · 127 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #404417
- Category
- Máy In 3D
- Published
Description
HevORT X-Carriage for the Dragon Burner
For my HevORT (CoreXY) there was no X-carriage that cleanly fits the
Dragon Burner, so I designed my own from scratch in FreeCAD.
The existing carriages are optimized for low mass and speed — this one
is built for stability and a universal mounting setup instead.
Features
-
- Direct mount for the Dragon Burner toolhead
-
- Integrated BTT Eddy USB adapter plate on the rear
-
- Cutout on top for a standard optical X-endstop
-
- Designed for MGN12H linear rails (HevORT CoreXY)
Print settings
-
- Material: PETG (ABS/ASA works too in an enclosure)
-
- Nozzle: 0.4 mm
-
- Perimeters: 4
-
- Infill: 40–50 %
-
- Supports: not required (print in the orientation shown)
-
### Notes
The optical endstop and BTT Eddy wiring/Klipper config depend on your
mainboard — check the full build write-up (design rationale, material
trade-offs and lessons learned) on
DE: https://devmaker.net/3d-druck/dragon-burner-x-carriage-hevort-freecad/
EN: https://devmaker.net/en/3d-printing/dragon-burner-x-carriage-hevort-freecad/
Designed & printed by Harald · devmaker.net
Print spec
- Formats
- 3mf
- Model files
- 5
- Total size
- 397.2 KB
- Largest file
- 127 KB
0 comments
You may also like 12 models
See all-

-

-
New -
New -
New -

-
New -

-

-

-

-

