
Giá đỡ Z phía sau MGN12H cho Voron Trident-R1
- Downloads
- 239
- Likes
- 60
- Views
- 2,211
- Remixes
- 0
- Comments
- 0
Files 13 11.7 MB
- WobbleX_3.1mm_TR8_Adapter_1782351306.stlSTL · 231.9 KB
- WobbleX_3.1mm-MGN12H_Z_Carriage_Rear_2-hole-_IGUS_1782351307.stlSTL · 1.2 MB
- WobbleX_3.1mm-MGN12H_Z_Carriage_Rear_3-hole-_Generic_1782351309.stlSTL · 1.2 MB
- WobbleX_3.0mm_TR8_Adapter_1782351310.stlSTL · 232.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #403772
- Category
- Máy In 3D
- Published
- License
- GNU General Public License v3.0
Description
MGN12H rear Z carrier for Trident-R1
CHANGELOG
-
01.05.2023: WobbleX - Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.
-
25.04.2023: Variable pin sizes for WobbleX carriers, since it's been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers.
-
15.04.2023: WobbleX v1.7, resized the pin holes too 2.9mm (the old/stock was 3.1mm and the pins would be loose and fall out).
-
15.04.2023: WobbleX v1.6, added recess for the WobbleX balls (missing in stock/MGN9H release too).
-
11.04.2023: Counterbore fix for all carriages & WobbleX v1.5.
-
11.04.2023: WobbleX v1.
-
30.11.2022: Initial release.
MGN12H rear Z carrier for Trident
Printing:
- Default voron settings, correct orientation, no supports needed!
Bom:
For "standard" carriers:
- Same as stock Trident except a MGN12H rail set.
For WobbleX carriers:
-
1x WobbleX WS8
-
1x MGN12H rail set
-
Stock Voron Trident screws etc.
Description:
-
Modifed Voron Triden r1 rear Z carrier to house a MGN12H block instead of MGN9H.
-
One version for IGUS chains (2bolt), and one version for the generic Chinese ones (3bolt).
-
Rail stop that's been sized to accommodate for a MGN12 rail.
-
WobbleX implementation.
You will loose a tiny bit of Z travel, otherwise it's not much to "negative" (quite substantial loss of Z travel with WobbleX, but that's not isolated to this mod, it's just the nature of the beast).
Pictures:
WobleX version:

10.5mm(old) vs 13mm(new)

- - -
In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!
Print spec
- Formats
- stl
- Model files
- 13
- Total size
- 11.7 MB
- Largest file
- 1.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-
New -

-
New -
New -
New -

-

