Ngàm gắn VESA 100x100mm cho loa Audioengine A2+

Mounting your speakers on a monitor arm is a great way to keep clutter off your desk, while keeping them close to your face. Since the Audioengine A2+ doesn't come with a ¼-20 mount on the bottom, I designed this mount to allow them to sit snugly without any risk of them falling out. Unlike the other designs I've seen, this doesn't require you to remove the stock rear plate, and doesn't interfere with any of the cables or controls.

The design is quite sturdy, and holds the speakers quite firmly. There's also a little cutout in the back to help with cable routing. To attach the mount to your VESA plate, you can use the normal M4 screws specified by the VESA standard. I recommend throwing a few nuts on the back for extra security, but they're not strictly necessary.

This model should be printable with minimal or no support. I've attempted to make the original Fusion design relatively flexible, so if you want to tweak the curves, tolerances, or mounting height of the speaker it should be pretty easy. Please let me know if you have any issues!