The Minfinite Notebook (Bản remix sổ tay Infinite Notebook)

A remix of Gazzaladra's "Infinite Notebook". Please show them some love over on Thangs: https://thangs.com/designer/Gazzaladra/3d-model/Infinite%20Notebook-1553629

DISCLAIMER: I'm only listing this as an original model because I remade it completely from scratch. I did not edit the original files (because I don't know how to, and I liked the challenge).

I wanted a version of the Infinite Notebook that was smaller, which Gazzaladra does provide, but it didn't have a pen slot, so I added a pen slot, and also replaced the use of rubber bands, because rubber bands age and are prone to breaking...and I eliminated the angled panels, so I could lay several on top of each other...and then I added the stencil slot on the back, because why not. 

Spine options range from 1 to 4 signatures.

What you will need:

Printed (at least 15% infill recommended):

• 1 Front

• 1 Back

• 2 Inner plugs

• 1 Spine of your choosing

• 1 Small stencil

• 1 Pen

Not printed:

• Some string for tying the paper signatures to the spine

• 2 small pieces of filament for inserting into the hinges

• Plain Letter or A4 size paper, cut in half horizontally and then folded in half again (make sure you print the correct models for your paper size)

• Super glue (I use Gorilla gel glue)

• Some elastic string for the clasp and for securing the pen

• 1 ink cartridge from a BIC Cristal with about half an inch cut off the bottom (if you find a cartridge that works better, PLEASE let me know)

Assembly can take up to an hour, depending on the size of the spine you choose. Please see the included pictures for assembly directions. All of the books shown were printed using Overture PLA Professional.

Please let me know if you have any problems with it, as it is definitely not perfect.

Edit: Now in A4 size!!!

Edit 2: NEW SPINE OPTIONS!!! Added spines with notches to add the new spine covers! Simply print the corresponding size of cover alongside the spine. Once the book is fully put together, slide the cover onto the notches on the spine. Glue can be used if you want it to be truly permanent.