Skip to main content
F3D
Heo Đất — Khe nhét xu phía trên + nút vặn dưới bụng dễ dàng… 1

10 images

Đồ Gia Dụng

Heo Đất — Khe nhét xu phía trên + nút vặn dưới bụng dễ dàng mở

By Claptomancy

Downloads
1
Views
65

Files 3 12.7 MB

  • piggy_bank_1781220149.scadSCAD · 10.5 KB
  • piggy_bank_plug_1781220150.stlSTL · 2.3 MB
  • piggy_bank_body_1781220151.stlSTL · 10.4 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A classic chubby piggy bank standing on four little trotters. Drop coins

in through the slot on top — they fall into the hollow body. Empty it by

unscrewing the bottom plug, whose **knurled rim you twist with your

fingers** (no tool needed), recessed in a pocket between the feet.

The whole pig is one print (snout, ears, curly tail, feet, top slot and

the internal threaded collar are all integral) plus a separate screw plug.

What's in this listing

| STL | What | Print pose |

|-----|------|-----------|

| piggy_bank_body.stl| The whole pig | belly-down (flat belly between the feet = bed) |

| piggy_bank_plug.stl| Knurled screw plug | knob-down |

Both are watertight single bodies — no supports. The flat belly (hidden

between the feet) is the print base; the four feet and the snout bump all sit

at or narrow toward the bed, so nothing overhangs.

Suggested: 0.2 mm layers, 3 perimeters, 12–15 % infill, PLA.

Using it

  1. Feed it. Drop coins into the slot on the back/top. It takes coins up to

  2.    Ø33 mm (US half-dollar 30.6, AU 50c 31.5, €2 25.75, UK £2 28.4 …) —

  3.    essentially any circulating world coin.

  4. 2. Empty it. Turn the pig over and unscrew the plug with your fingers —

  5.    the belly pocket has three big finger-scoops so you can pinch the knurled

  6.    knob and twist. The inside floor is a funnel that feeds every coin to

  7.    the hole, so they tip straight out; screw the plug back in.

Parametric source

The OpenSCAD .scadis included. Key knobs at the top of the file:

  • coin_d/ coin_t— top slot size (default Ø33 × 3.2)

  • - body_l/ body_w/ body_h, wall— pig size + shell thickness

  • - foot_d, foot_x, foot_y— foot size + stance

  • - thr_d, thr_p, thr_len, thr_clear— screw thread (Ø38, 4 mm pitch);

  •   if the plug is tight raise thr_clear, if loose lower it

  • - knob_d, pocket_d, pocket_h, finger_d— finger knob + pocket + scoops

  • - funnel_rise— how steeply the inside floor funnels to the hole

Fork it, change the size, share what you make.

Read more Show less

Print spec

Formats
scadstl
Model files
3
Total size
12.7 MB
Largest file
10.4 MB

0 comments

See all