Mô hình Miyoo Mini Flip tỉ lệ 1:1

I made this because I couldn't pick which handheld to get and I wanted to know if this (very small!) one was comfortable for my hands. It makes for a nice model to jsut have around though, looks and feels very nice.

Details

All significant dimensions are accurate, and I did the best I could with stuff such as face buttons and triggers.

I plan to release an updated, more accurate version if I end up purchasing the device.

PRINT INSTRUCTIONS

Print with supports on and ideally paint on some supports to the "ledge" at the edge of the screen, any face buttons that don't already have them, and maybe for the bumper/triggers too.

I used .16mm layer height but in testing I used .20 as well and it worked fine.

I originally intended to put a piece of filament through the hole for the hinge but when I put on the screen it somehow snapped into place????

I may add an updated version with a bigger hole since idk if the filament will fit, but until then, you can use a piece of a paper clip and it works fine.

Any and all feedback is appreciated. Thank you!

Shoutout to u/sundownersport for posting the measurements used for this design!