Thư viện các đế kẹp/tag MOLLE/PALS

Templates for further customization, for example to create clips with emblems to show on your backpack or vest. Import in FreeCAD or any other software.

By design the face itself is not at the same height as the belt allowance—you will need supports.

• Designed to be printed with a 0.2mm or 0.4mm nozzle.

• 6–4 walls, 20%+ infill

• Switch to ‘concentric’ for the top surface pattern above the layer where the belt allowance ends.

• The ideal material for this is: PA66

  • … else use something with a good layer adhesion (>30 MPa) and UV-resistance

Design decisions:

• The “belt openings” are form B for now:
  long and short legs meet at an angle pointing to one side and not into the center.

• … it should be tapered at 2× 45°, but for easier printing it’s steeper with 2× 60°.
  That taper makes it easier to guide the belt through by pinching it.

• Chamfered at points of interaction to reduce wear and tear.

Revisit this page for updates, such as more variants. :-)