Giá đỡ huy hiệu Enamel GameOverse

Printer settings:

• .1mm height

• .4 Nozzle

• 40% infill

• PLA

I wanted to make a holder for the enamel pins that plays off the idea that they're Gameboy cartridges, so this stand has the same shape as the back of a Gameboy. The curve on the outside and the stark sharp straight inside profile.

Did a lot of trial and error (seen in the photos) to get a nice fit, but not too clunky!

Pretty simple print. Just slide the sucker in when its done!

I don't think it needs to be weighted all that much, I still jacked up the infill just to help. The pins naturally lean back towards the big flap so it only tips when pushed.