Mini Papermaking Frame

This is a small papermaking mould and deckle for making your own handmade paper. No hardware or separate mesh is required, as the infill pattern acts as the mesh!

For information on how to use it, please check out our Kickstarter campaign!

Settings:
Material: Any (PLA is fine)
Layer height: 0.2 mm
Perimeters: 2
Infill: 15% Grid

IMPORTANT: Make sure to include a height range modifier for the first two layers (0.4 mm) for the _mouldBottom.stl and set the bottom solid layers and top solid layers to 0. Also, increase your infill to 50% Grid. If you notice that water drains too slowly when using the frame, decrese the infill percentage.