Mô hình súng mô phỏng CZ Shadow 2 ACE cho Meta Quest

After watching a lot of YouTube clips, I was really curious to try the ACE dynamic shooting simulator. The only thing holding me back was the cost of the "gun": $200 just to try something that might disappoint me was too much. Eventually, I found several 3D printing projects online and created remixes to suit my needs. This is a remix of two different projects, one for the frame and the other for the FCU. For the frame, I cut off the protruding part of the magazine to simplify positioning on the print bed. The cutted magazine will be glued. For the FCU, I modified the original Glock trigger by crossing it with a CZ one. You certainly won't get the same trigger pull as the original ACE simulators, but in my opinion, the system is more than satisfactory and, above all, economical. I added an optional accessory for the mag release button  to make it more effective. Also this have to be glued. To weigh down the toy, I used 4.5 cal air gun pellets and silicone sealant. All files are correctly positioned on the plate ready to be printed. I used a Creality K1, PETG, 5 walls, 15% infill, 0.4 nozzle and 0.2 layers. For sure also PLA have no problem.

Required: 1 x 3x30 pin, 1x3x25 pin 3 x 3x20 pins, 1 x 3x5 grub screw, 2 x 5x15 springs, 4.5 mm cal. steel pellets, silicone sealant.

It is necessary to thread the FCU with an M3 tap to accommodate the grub screw to lock the controller block.