Walther PDP C Trigger Guard (Bản Remix)

I remixed https://makerworld.com/en/models/2054576-trigger-guard-for-walther-ppq?from=search#profileId-2217793 found on Makerworld for a Walther PPQ to fit my PDP C.  It fit fairly well as designed for the PPQ, but I also wanted it to fit with a light/laser installed so I cut the front down, some of the back 'wings' and filleted the edges a bit better than the OEM.  I also put a 6mm hole in the 'wings' for a lanyard as I carry in a fanny pack with a cord attached to the guard so it pulls off automatically as I draw the PDP out.

Kudos to the original Modeler for the heavy lifting getting it to something that could be mixed further for a better fit.  The obj_1_Korper1.stl is the original file.  My remix is the Walther PDP Trigger Guard Remix - V3.stl.

I printed this 'flat on the bed' with organic supports under the back curved up piece and 'wings' in PETG with .2 layers, 4 walls and 3 top and bottom surfaces.  I used cubic infill on this at 30% and it feels sturdy.  Fairly, I've not had a chance to use it much yet in practice.  It prints almost slightly loose so you might print it with the Y axis at 99.5%, etc., to get a bit tighter fit if you like.  Enjoy and go see the OEM and comment there as I was the only maker in about 14 months and the guy did a nice job getting it to this point!  It has 2 clip/friction surfaces inside that grab the trigger guard at the front and bottom.