Phụ kiện ebb36 cho Midwatch

Pose-adjustable ebb36 mount for the Midwatch extruder:

This mount compensates for the backlash adjustment, without dramatically changing the position of the ebb36.

If you just want to attach an ebb36 and don't mind the board sitting lower (or you use XoL carriage) then you should use this instead:

You will need:

• 10mm aluminium standoff (or equivalent) tapped at both ends m3

• 18mm aluminium standoff (or equivalent) tapped at both ends m3

• 1x m3 6mm shcs screw

• 1x m3 8mm shcs screw

• 2x 3x4x5 normal voron heatsets

• 2x m3 25mm shcs screws to mount the cover, or 1x m3 10mm shcs screw and 1x8mm if you don't use the cover.

Put a heatset in the back of the plate, and another one in the offset piece.

Attach the standoffs to exposed ends of screws protruding through the back of the stepper motor from the front. Looking from the back of the toolhead, the short 10mm standoff goes on the left, the long 18mm one on the right.

Use the 8mm screw to attach the offset piece to the short standoff, using the hole which does not contain a heatset. The result should have the heatset facing towards the back of the toolhead. The top of the heatset should now be at the same height as the top of the 18mm standoff.

Attach the plate to the offset piece using a 6mm m3 screw passing through the radial slot on the plate and into the heatset of the offset piece. You should now see how you can adjust the pose of the plate so the strain relief is vertical.

Finally, stack the toolboard and cover together and use long screws to join the whole stack together. One of these ends up in the heatset in the plate, and the other ends up in the 18mm aluminium standoff.