Skip to main content
F3D
Giá Đỡ Ống Nhân Giống Cây Cho HSW 1

5 images

Đồ Gia Dụng

Giá Đỡ Ống Nhân Giống Cây Cho HSW

Remix of Tường lưu trữ Honeycomb By RostaP

By thiebes

Downloads
15
Likes
11
Views
281

Files 1 165.5 KB

  • Propagation_Tube_Holder_for_HSW_1780289873.stlSTL · 165.5 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I wanted a way to hang propagation tubes on the wall and have them interchangeable and also look good and i think with the help of the HSW i have nailed it. This simple Propagation Tube Holder will hold any tube that has a neck width of ~35.5-37mm, i will link the exact tubes i use below. I printed these in PLA+ with standard 2 wall loops and a 15% infill which pretty much makes the holder bit solid. I have not had any snap on me since i started printing them this way. I will post some more photos later on once i get the full setup i have in mind, but for now here is the model. Hope someone can find and enjoy it =D

Here is a paid link to the exact tubes i used from amazon - https://amzn.to/4uRvtWX   They come in 12/24/48 pack.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
165.5 KB
Largest file
165.5 KB

0 comments

See all