
Miếng đệm thay thế cho trống Guitar Hero
- Downloads
- 3
- Likes
- 0
- Views
- 60
- Remixes
- 0
- Comments
- 0
Files 1 145.6 KB
- DrumPAD_1780230734.stlSTL · 145.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #392358
- Category
- Dụng Cụ Tiện Ích
- Published
Description
This is a print used to replace a broken drumpad from my guitar hero drum kit.
It is compatible with the Band Hero Wireless Drum Kit Controller, Model no. 95519.808, although i think it might be compatible or adaptable to other models as well.
You will need to remove the three rubber feet from the old one, CAREFULLY remove the piezo sensor and apply it to this one. I used some super attack and after a while it held.
You can see how to put it togheter in the pictures with a prototipe. The actual model is the one of the cover pictures and it's improved from the one in the assembled pictures, because it allows for the rubber pad to fold inside the rim.
The rubber feet holders have a bit of an overhang but i printed it without support, cleaned it up and it was fine. I guess you could print it with supports too but then you'd have to clean up even more..
Had a hard time finding a replacement so i decided to make my own :)
Hope it's helpful!
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 145.6 KB
- Largest file
- 145.6 KB
0 comments
You may also like 12 models
See all-
New -
New -

-

-

-
New -

-
New -
New -
New -

-


