308 | 7.62x51 | Hệ thống nạp đạn nhanh và lưu trữ cho AR-10

All in one storage and speedloading solution for AR-10 / SR-308 / SR-25 / LR/SR Pattern magazines.

Don't waste time fiddling with rounds at the range. Prepare ammo at your own leisure and arrive ready to shoot.

This speed loader & storage system keeps rounds organized, protected and correctly oriented during transport and loading.

A flange engages the extractor groove to prevent rounds from tipping and landing in the wrong orientation during loading. It also keeps them from moving around during transport.

The plunger is sized so that when it is pushed all the way down, it goes only 2 millimeters into the the magazine, this ensures that the last round is loaded, yet prevents damage to rounds and magazine.

Rounds are held in place by inner tabs along the sides, so they will not fall out. The end caps are mainly there to keep dirt out.

16 clips with end caps fit comfortably in a standard M19A1 can. You can fit 18 clips if you do not mind squeezing them in or if you remove the end caps.

That is 160 or 180 rounds per can versus 300 loose rounds, but I do not have the kind of money where that makes a difference for a single visit to the range.

STL files are oriented the way I print them. The clips are meant to print standing rather than upright at full height. This also puts the layer lines opposite to the direction of movement for the plunger and caps, which reduces friction and noise.

The caps are tight at first. Put a little Vaseline/petroleum jelly on them, then put them on and take them off a few times. Wipe them clean afterwards and they fit perfectly.