Skip to main content
F3D
Kẹp giữ vỏ quạt cho máy WeHeat Sparrow 1

2 images

Đồ Gia Dụng

Kẹp giữ vỏ quạt cho máy WeHeat Sparrow

By garethky_1988

Downloads
4
Views
61

Files 1 40.6 KB

  • weheat_sparrow_rooster_beugel_1780152702.3mf3MF · 40.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#390251
Category
Đồ Gia Dụng
Published

Description

The fan shroud of the WeHeat Sparrow heat pump has the tendency to bow out a bit. This clamp holds it in place.

The manufacturer supplies an OEM clamp on newer installs, but if you already have a WeHeat Sparrow heatpump installed this allows you to add the clamp afterwards.

The design is inspired by (an image of) the OEM clamp/bracket.

Make sure to print it in a material which can withstand the outside weather and print it solid (thick walls) so it stays in place and shape when the fan shroud tries to bow out.

I have fixed mine in place with a stainless wood screw. It threads into the foam housing of the unit, anywhere from 4 to 6cm thread length is probably fine. Don't use too thin screws because they might get pulled out again.

Read more Show less

Print spec

Formats
3mf
Model files
1
Total size
40.6 KB
Largest file
40.6 KB

0 comments

See all