Đồ chơi Fidget Infinite Pop-Up EVO

Enjoy endless clicking fun with this "EVO" version of the popular fidget toy! After reading hundreds of comments I've implemented the following improvements:

Easier assembly! - ..but please still read the instructions

Looser tolerance on the buttons - Less break-in required

Less resistance on the snap - easier on the fingers and quieter

Redesigned lever mechanism - longer life for even more fidgeting

Extra tabs to hold housing halves together - less likely to pop open

Fuzzy skin areas for better grip

Color schemes! - Two color profiles included for AMS or for manual filament change.

Follow the assembly instructions below and don't forget the grease!

Assembly:

Print the parts - note that PLA Basic, PLA Matte and PETG HF are recommended. Use other filaments with discretion.

1. Make sure the buttons move up and down freely.

2. Place the triangular lever between the buttons flat side down. Move the buttons up and down for better access.

3. Place a dap of Lubricant Grease center of the lever and a tiny amount on the six corners of the lever. Use the grease provided with your Bambu printer (NOT Lubricant Oil. It will also work but will find it's way out and into your fingers).

4. Snap the other half of the housing in place.

5. Break-in and distribute the grease by pushing the buttons and by rotating the buttons by a few revolutions every once in a while.

Enjoy! If you have any issues, please leave a comment and I'll help you out!