Ngàm gắn Tiny Paddle cho Quansheng K1

Printed on an Ender 3 pro with

• PETG

• 230 degree nozzle 73 degree plate

• 20% infill

• support enabled

If you flip the model so it prints with the side that touches the radio down to reduce supports you may end up with a tiny flange that needs to be trimmed off depending on your bed temp and initial layer settings. I think it prints better that way and hitting it with an x-acto is no biggie. 

The tiny paddle goes in to this print SNUG. It's supposed to. On my paddle, the solder points where the 3.5 plug meets the board were a little long. I trimmed them down to slide into the print easier.

Info on modding your K1 here: https://github.com/briand/uv-k1-k5v3-firmware-custom/releases/tag/beta2