Skip to main content
F3D
Marker vị trí bàn chân & bàn tay USPSA/IDPA 1

2 images

Thể Thao & Ngoài Trời

Marker vị trí bàn chân & bàn tay USPSA/IDPA

By Tobi

Downloads
7
Views
99

Files 2 356.5 KB

  • handprint_8_inch_1778883613.stlSTL · 141.9 KB
  • footprint_11_inch_1778883614.stlSTL · 214.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A right hand and right foot silhouette. both are 3/8" thick. The foot has a spine with reinforced holes for long nails up to 1/2" diameter and large chamfers to help the head sit below flush as well as channels to aid in removal. The hand has 4 chamfered slots for velcro straps or zip ties and a chamfered hole for a drywall screw. These can be mirrored in the slicer for the left version and the hand should probably be printed as a Left and Right version as well to provide a similar texture for both hands. With 4 perimeters and 8% infill, the foot should take just over 2 hours for one side, and the hand should take just over 1 hour for one side.

Both models should be printable without any supports.

You may want to add a few pieces of grip tape to the top surface of each foot and spend some time to bury them flush with the surrounding dirt to avoid tripping or slipping. Remove feet from ground carefully, the slots leading into the chamfer should provide enough space to get a small screwdriver under the head of the nail.

Have fun and be safe!

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
356.5 KB
Largest file
214.6 KB

0 comments

See all