Skip to main content
F3D
Bài test co rút kích thước theo trục… 1

3 images

Máy In 3D

Bài test co rút kích thước theo trục (Axis dimensional shrink test)

By tonyv

Downloads
10
Likes
1
Views
67

Files 2 19 KB

  • axis_dimension_test_1778872636.stlSTL · 18.6 KB
  • axis_dimension_test_1778872637.scadSCAD · 347 B

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a small part to measure dimensional changes (shrink) in each axis after printing. It is designed for use with Filament (sinterable high-metal content filament) and other materials that will go through a post-printing process that will alter their dimensions. I kept the part small to minimize wasted material, as these materials tend to be significantly more expensive per unit of volume than other materials.

All measurements on this part are nominally multiples of 5mm. You can print it, write down the as-printed dimensions, then sinter the part and measure the shrink ratio. This will tell you how much shrink to account for in subsequent prints. For example:

As-printed measurement (x axis) = 20mm

Sintered measurement (x axis) = 18.8mm

18.8 / 20 = .94 = 94%

100% - 94% = 6% shrink in x

1 / .94 = 1.06382979

Therefore, scaling the model up by a factor of about 1.064 in x should compensate for the shrinkage in this example, resulting in a correct dimension after sintering. X and Y should end up with the same scaling factor, but Z may require a different scaling factor, which is why the axes are labelled. You may then want to print the test again with the scaling factor applied to check that the post-sintering dimensions are correct.

Read more Show less

Print spec

Formats
scadstl
Model files
2
Total size
19 KB
Largest file
18.6 KB

0 comments

See all