Bản remix cho K1C TPU Holder

This is an addition to the original Mr. TVR K1C tpu spool holder. you can perform a cut on the female threaded side if you have a non-standard size roll although i gave a decent amount of wiggle room!

I used low infil (20%), happened to use petg but id imagine PLA ABS etc would be no problem. i used supports just to hold the outer ring with the threads pointing upwards (the ends that go into the holder should be touching the print bed, facing down). i changed the seam position from "aligned" to "random" in an attempt to give the threads an easier time. i did not try with aligned, YMMV