Skip to main content
F3D
Nắp (Cap) và Hood cho máy ảnh Werra 1/2, V1 1

3 images

Dụng Cụ Tiện Ích

Nắp (Cap) và Hood cho máy ảnh Werra 1/2, V1

By Zdenek_2515781

Downloads
1
Views
104

Files 2 503.6 KB

  • Werra_1_Cap_V1_1778671845.3mf3MF · 252.9 KB
  • Werra_1_Hood_V1_1778671846.3mf3MF · 250.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Werras are great cameras, they are stylish and technically competent. Unfortunately many are missing their hood and caps.

I made this model to replace the missing cap and hood on my Werra I, and I would like to share it in the hope that it can be useful for other Werra users.

This model fits Werra 1 and 2 with the triple start thread.

This model was successfully printed with PLA and PETG, and tested to be interchangable with factory hood and caps, both plastic and metal version.

Future versions:
As of May 2026, This is the current expedient version V1. I'm hoping to upgrade it to V2 with dual colour once INDX is available.

Printing Suggestions:
Works with PLA and PETG.

Cap:

0.4mm nozzle
0.15 layer height.
Threaded side up.
Top/Bottom fill pattern: Hilbert Curve
Avoid crossing perimeters
Seam Position: Random

Hood:

0.4mm nozzle
0.15 layer height.
Camera side down.
Avoid crossing perimeters
Seam Position: Random
Non reflective color on the inside (Matte black)

Afterfinish: The triple start thread where it mates with the camera has very tight tolerances, make sure you clean off any blobs and imperfections before putting it on the camera.

IMPORTANT: I have included a cylindrical modifier on the hood for fuzzy skin/texture for the outside perimeters. It should pull up correctly on Prusa Slicer but you'll have to re-configure it for Orca Slicer and others.

I would appreciate any feedback so I may improve on this model, and also I would like to know if there is any interest in doing one for the Werra 3.

Read more Show less

Print spec

Formats
3mf
Model files
2
Total size
503.6 KB
Largest file
252.9 KB

0 comments

See all