Skip to main content
F3D
Bệ nâng cho Anker 3-in-1 Cube Magsafe Charger 1

2 images

Dụng Cụ Tiện Ích

Bệ nâng cho Anker 3-in-1 Cube Magsafe Charger

By Sven ☠ 2157 ☠ 2157

Downloads
26
Likes
1
Views
133
Remixes
1

Files 1 29.8 KB

  • ANKER_3-in-1_CUBE_MAGSAFE_RISER_1778665145.stlSTL · 29.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

Description

I always felt that the Anker 3-in-1 Cube Magsafe Charger was a little low in terms of clearance. Since I have an iPhone Max, the bottom of my phone was always too close to the surface. Thought that an increase in height would make the charger easier to take on/off devices. The added height also gives more clearance for the apple watch band. Charger was purchased from Amazon.

-

Model Design

I tried to give the riser as clean a look as possible while keeping the lines of the charger transition into the riser as seamless as possible. The notch at the back of the riser should give more than enough clearance for a wide variety of different sized USB C cables.  This design was created in Tinkercad.

  • Riser
  • Product (image from Amazon)
  • No Riser (bottom of phone is very close to the surface)
  • With Riser (gives more clearance)

-

Instructions

  • Photos show the orientation that I've had the best prints with so far.
  • PrusaSlicer Generic PLA settings were used. No supports necessary for this print.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
29.8 KB
Largest file
29.8 KB

0 comments

See all