Skip to main content
F3D
Đĩa thay thế RoboUp T1200 Pro Phiên bản 2.0! 1

2 images

Đồ Gia Dụng

Đĩa thay thế RoboUp T1200 Pro Phiên bản 2.0!

Remix of Đĩa cắt kèm miếng đệm cho robot cắt cỏ RoboUp T1200 Pro By Buzz_2057089

By Oleks_1671286

Views
42

Files 2 247.2 KB

  • RoboUP_T1200_Pro_Blade_Spacer_1778640912.stepSTEP · 28.6 KB
  • RoboUP_T1200_Pro_Cutting_Disc_1778640913.stepSTEP · 218.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Same print setting recommendations as with the original version of this design still apply (100% solid, output each object complete if printing all on the same print bed, etc.). Also, the files attached are STEP files for the same reasons as the original listing.

Note: You can install the standard number of blades if you wish, just make sure they are equally spaced around the disc to keep it balanced.

WARNING: This version of the design requires M4 Hex Nuts similar to the ones on this Amazon listing - https://a.co/d/0cjZ86th

If you want a design where there are no additional parts other than what come stock with the mower, use the original design (though it is a bit harder to put together).

See photos for assembly prior to installation on the machine.

Actual assembly steps:

- Insert spacer piece into one of the disc holes, aligning the hex edges with the hex cavity (make sure the circular part of the spacer goes through the disc).

-Insert M4 hex nut into hole and cover with finger to keep in place for the next two steps.

-While holding hex nut in place, rotate disc over, place blade over spacer, then install stock RoboUP screw through spacer and into nut.

-Tighten screw until screw pulls nut tight, but DO NOT OVERTIGHTEN. It is possible to crush the spacer.

Note: Because the stock RoboUP screws come with a thread locker on them, you only need to tighten things enough to hold the blade on the spacer so that the blade will spin when the mower spins the disc.
 

Short video clip of assembly to show how blades will spin freely:

https://drive.google.com/file/d/1ocAvlfzS38yAozN8vpaDKWdfSvEhosmz/view?usp=sharing

Read more Show less

Print spec

Formats
step
Model files
2
Total size
247.2 KB
Largest file
218.6 KB

0 comments

See all