
Vỏ XT60 - Bản Remix
Remix of Vỏ Jack XT60 | Gen2 By _755856
- Downloads
- 14
- Likes
- 3
- Views
- 102
- Remixes
- 0
- Comments
- 0
Files 3 1,020.2 KB
- xt60_housing_-_remix_-_v37_1778226506.stepSTEP · 636.6 KB
- xt60_housing_side1_-_remix_-_v37_1778226507.stlSTL · 187.9 KB
- xt60_housing_side2_-_remix_-_v37_1778226508.stlSTL · 195.7 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #378724
- Category
- DIY
- Published
Description
Remix (slotted only) with the same external dimentions. Parts to be connected using M3 x 8mm screw (M3 x 10 is too long) and M3 hex nut.
I do not know if XT60 connectors I have at home are genuine or not and what are the differences between them %-) However, they fit into original connector (that I remixed from) with minor issues (too hard to put wire and a small gap between parts as not enough width). So I believe if you can use original model, my model will work for you as well.
-
Added "stop" that holds connector in place (no need to glue it);
-
External grips;
-
Hex hole for nut;
-
Additional inset for better positioning;
-
More room for cables;
-
Top/bottom walls' width extended from 0.7mm to 0.8mm (that is better for printing with 0.2mm layer height);
-
XT60 connector's room extended from 8.04 to 8.2mm (XT60 width by spec 8mm);
-
STEP file published.
Should be printed "grip sides on table" without supports using layer height 0.2mm and line width 0.43-0.5mm.
May the electric power be with you.
Print spec
- Formats
- stepstl
- Model files
- 3
- Total size
- 1,020.2 KB
- Largest file
- 636.6 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-
New -

-

-


