Extension pin cho loa PEAQ PPA20BT

This is a 3D printed extension for the PEAQ PPA20BT speaker, designed to add extra internal space for a larger battery.

The extension attaches to the original bottom section, increasing the available volume while keeping the original casing in place. It allows you to route the battery cable into the added compartment.

Important:
The 3 mounting screws are not evenly spaced and do not form a perfect equilateral triangle. The design matches the original layout, so orientation matters during installation.

You will also need to drill or cut a hole in the original bottom casing to allow the cable to pass into the extension where the battery will be placed.

Required additional parts:

• Longer screws (to match the added height)

• 3x rubber pads (Ø 7 mm, at least 2.5 mm thick, round)