
SMC-PAD Sensitivy Fix – Miếng insert in 3D chỉnh độ nhạy
- Downloads
- 0
- Likes
- 0
- Views
- 37
- Remixes
- 0
- Comments
- 0
Files 1 387.6 KB
- smc_pad_fix_1778206750.stlSTL · 387.6 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #377521
- Category
- DIY
- Published
Description
I picked up an SMC-PAD for pennies, but as the saying goes, "you get what you pay for"—the sensitivity leaves much to be desired. Looking for a budget-friendly fix, I stumbled upon OwlMuso's video about using electrical tape to adjust the pads.
I wanted a more "precise" solution, so I created this 3D-printed insert. Follow OwlMuso's video to disassemble the unit (WARNING: THIS WILL VOID YOUR WARRANTY. DO THIS AT YOUR OWN RISK). Instead of using tape, place this insert between the silicone pads and the graphite-transparent sheet. Reassemble and enjoy!
Print Settings: Print in TPU. I used a single 0.2mm layer, but two 0.1mm layers (perhaps with ironing) might provide an even smoother result, though I haven't tested that yet. Pull gently from the heated bed to prevent tears or deformation.
Full disclosure: The image of the printed model was AI-generated because I didn’t want to take my SMC-PAD apart again after installing the insert. However, the 3D model itself was entirely human-made.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 387.6 KB
- Largest file
- 387.6 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-
New -

-

-

