Vỏ máy in 3D cho node Meshtastic 'fake18650tec'

The pigtail must be inserted before the battery. The button as well.

The button is pressed and slid along one side. Once in place, it pops out and locks into position.

It is recommended to solder the wires to the button before inserting it.

The battery must be inserted carefully; it's a very tight fit.

The Faketec needs to be soldered with pins.

Double-sided tape is needed to attach the Faketec to the body and to close the lid.

2mm for the lid. 2, 3, or 4mm for the Faketec/body

Mini push-button power switch = 1208YD

Battery = 18650

CC BY-NC-SA 4.0 + exception: private individuals may sell up to 5 units/month on hobbyist platforms (eBay, Etsy_, etc.) with attribution. Corporate/mass production requires commercial license_