Skip to main content
F3D
Bộ chuyển đổi bộ lọc Levoit 300 cho quạt 140mm 1

2 images

Máy In 3D

Bộ chuyển đổi bộ lọc Levoit 300 cho quạt 140mm

By leejsmith

Downloads
53
Likes
11
Views
643
Comments
1

Files 2 419 KB

  • levoit-300-140-filter_1766293224.stpSTP · 14.1 KB
  • levoit-300-140-filter_1766293225.stlSTL · 404.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#3751
Category
Máy In 3D
Published

Description

My room does not have good ventilation and I have to run a large 500cfm fan through a duct to a small gap in the only window of my workshop so I am always looking at ways to filter the air from printing and especially since I started to resin print. I did buy the Levoit LV-H28 and it works well, but has an annoying soft power switch so I can forget to turn it on. While looking at the bigger 300 series models I saw the Toxin removing filter and decided to buy that and a 140mm fan with very high static pressure designed for radiators.  both arrived from amazon and I quickly tested a pressure fit from the 3d printed part to the filter and then finished the 140mm fan mount on the top. The filter has a foam seal so with the very good pressure fit only the fan needs a gasket of some sort to make sure the air is pulled through the filter.

The fan I used is a Artic P14 PWM PST 140mm fan 12v with 2.4 mm/H2o

Filter is the Levoit Core300-RF-TX but any of the 300 series filters will work.

Read more Show less

Print spec

Formats
stlstp
Model files
2
Total size
419 KB
Largest file
404.9 KB

1 comment

See all