Ishidoro cỡ lớn (large Ishidoro)

I found the original lamp design by AlCampCW to be a bit too small and some things didn't fit right, so I redesigned it completely. See text at the bottom for all differences.
The assembled Ishidoro can also be found as a STEP-file in the download section.

You need to print:

• 2x BASE_LED-version
• 3x LEG
• 1x ROOF or ROOF-variant
• 2x SCREEN_triple
• 2x SMALL_SCREEN_triple

All files are optimized for printing with 0.2mm layer height.

Print Settings

Printer Brand: Prusa

Printer:  i3 MK3 (modified)

Rafts: No

Supports: Doesn't Matter

Resolution: 0.2mm

Infill:  15-20%

Filament: Fillamentum Timberfill cinnamon / light wood tone

Notes:

printed with 0.6mm nozzle. bases might need supports for the indent in the middle

Post-Printing

Assembly

Bend the screens, so they fit the notches and gently push them in.
Insert the legs straight from below and tilt them up until they snap into place slightly.

Electronics

There is ample room inside the base to place electronics for a LED. I chose a case for three AAA batteries to power a white LED (hidden under the silver tape) with a large beam angle.

not pretty, but it works…