Nâng cấp & phụ kiện cho Artillery Genius Pro

If you have any question  leave a comment and I will do my best to answer 

Nozzle cleaner

The hole for the poly is a bit under sized, use some force to convince it to go in.

klipper config in the files.

Hardware:

Nema 17 
Stepper driver AT2100
Poly 16 teeth bore 5

1 m3*30mm for the end stop

1 m3*20mm screw, lock nut and washer.

• 0.2 to 0.44 layer height with 0.6 nozzle 
• 2 perimeters
• 10% infill

5015 Fan duct

On my fan I had to remove with a knife one of the clips on side of the fan to make it fit in the duct. 

Hardware:

5015 fan 24V - Dual Ball

2 m4 threaded inserts

2 m4*20mm screws 

2 m3*8 screws and washers 

• 0.2 layer height
• 2 perimeters
• 10% infill

Extruder cover

Hardware:

You will need a small piece of foam or rubber behind the ribbon cable

• 0.2 to 0.44 layer height with 0.6 nozzle 
• 2 perimeters
• 10% infill

4020 Back bracket

Will need to tap M5 threads in the 2040 extrusion, the bracket will hold 5mm thick foamboard. 

Hardware:

2 m5*10mm screws

• 0.2 to 0.44 layer height with 0.6 nozzle 
• 2 perimeters
• 10% infill

Genius pro Leg

Nothing to add, just print it and stick it in, no hardware needed.

• 0.2 to 0.44 layer height with 0.6 nozzle 
• 2 perimeters
• 10% infill