Skip to main content
F3D
Hộp & Ống Trụ Lưới Hex Mesh… 1

2 images

DIY

Hộp & Ống Trụ Lưới Hex Mesh (Hex Mesh Containers and Cylinders)

By Jeeter_1524857

Downloads
140
Likes
10
Views
476

Files 11 36.7 MB

  • 70_MM_Dia_20_Hex_Platform_1777768080.stlSTL · 587.9 KB
  • 100_Dia_22_Hex_Lid_1777768081.stlSTL · 402.5 KB
  • 100_MM_Dia_22_Hex_Open_Cylinder_1777768082.stlSTL · 3.8 MB
  • 70_MM_Dia_20_Hex_LIpped_Cylinder_Mesh_Bottom_1777768084.stlSTL · 4.4 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

I like the look of hex mesh, so I have started parameterizing them in Fusion 360 starting with cylinders.  I have included 100 mm Diameter and 70 mm  *.stls for:

  • Open both ends cylinder
  • Cylinder with a solid bottom
  • Cylinder with a hex mesh bottom
  • Cylinder with a slot in one side
  • Lid/end cap. 

I also include little base with legs that works for 70 MM diameter model with the mesh bottom cylinder.  Friction is enough to hold it in place.

The advantages of the hex mesh:

  • They use a lot less filament 
  • I think they have a nice clean look.  

The disadvantages are they are:

  • relatively large *.stls, 
  • tend to print slower because all the retractions.
  • no good for storing small objects.  

Other Notes: 

  • The models can also be stringy but I just blow on them a couple of seconds with a heat gun set on high and they all dissolve.  (Literally a couple of seconds, you don't want to melt your model itself) 
  • These print fine for me with no supports, even the little base.   
  • PLA works fine.  I've used PETG for the little base because I generally use the legs where these might get wet like a bathroom sink.  I have also printed the little base using FLEX for the legs and PETG for the top and it worked fine.
  • The 20 or 22 hex in the model name refers to the number of hexes around the circumference at the give height.
  • Diameter is the ID

If there is interest, I can upload the Fusion file.  There a 4 parameters you can set a value for and the rest it calculates.  

Be aware that:

  • Fusion can take a long time to run thru all the recalculations as you change parameters.  (Fusion struggles with rectangular and circular patterns)
  • The model is also not bulletproof.  Some seemingly valid values won't work (e.g. NumHexes = 25 and Diameter = 70 fails)

Read more Show less

Print spec

Formats
stl
Model files
11
Total size
36.7 MB
Largest file
4.7 MB

0 comments

See all