Skip to main content
F3D
Bracket giữ trục (Axle) cho Awesome Filament Spool Rewinder… 1

1 image

Máy In 3D

Bracket giữ trục (Axle) cho Awesome Filament Spool Rewinder - Upgraded

By PreZ_54463

Downloads
26
Likes
1
Views
225

Files 1 48.6 KB

  • Axle_Retention_Bracket_1777772332.stlSTL · 48.6 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#367741
Category
Máy In 3D
Published

Description

I found that, with the Awesome Filament Spool Rewinder - Upgraded, the axle underneath the sled, when printed, was too tight.  So I had to shave it a little to fit in my bearings.  This got everything fitting, but at high speed (with the motor), the axle could start to slide out of alignment, until it pulled itself from the drive gear.

I made this bracket (using the rewinder main body as negative space) to act as a clip that can be applied to the rewinder after the axle is fully installed, and will prevent it from sliding out if the fit in the bearings, like mine, is now slightly too loose due to shaving.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
48.6 KB
Largest file
48.6 KB

0 comments

See all