Skip to main content
F3D
Giá treo băng keo Wall Control (Wall Control Tape Holder) 1

1 image

Đồ Gia Dụng

Giá treo băng keo Wall Control (Wall Control Tape Holder)

By nm3d_108515

Downloads
160
Likes
53
Views
1,301
Remixes
1

Files 2 285.8 KB

  • wc_-_tape_holder_left_1777732809.stlSTL · 143.5 KB
  • wc_-_tape_holder_right_1777732810.stlSTL · 142.3 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

A Wall Control slot version of the Pegboard Tape Holder by @rordaz. This supports the Wall Control slot + peg system. Each side uses dual slots for increased stability. I use my dual slot base from here: https://www.thingiverse.com/thing:4097266 and combine it in Tinkercad.

Category: Organization Summary

A Wall Control slot version of the Pegboard Tape Holder by @rordaz. This supports the Wall Control slot + peg system. Each side uses dual slots for increased stability. I use my dual slot base from here: https://www.thingiverse.com/thing:4097266 and combine it in Tinkercad.

Printer Brand:

FlashForge

Printer:

Creator Pro

**Rafts:**

No

Supports:

Yes

**Resolution:**

.3mm

Infill:

30%

**Filament:** Prusament PETG Orange

Notes:

The best way is to print this is with both slot pegs having very high infill with top and bottom layers. However this would disrupt the 'hollow' look of the original design since the actual holders would have at least a bottom layer on the printing surface side.
(there are work arounds using S3D to merge the separate pieces each with their own profile).

As a compromise, I set 3 perimeters and allow the lower slot peg to match the 'hollow" infill of the arm, and then use the Variable Settings Wizard in S3D to make the upper slot peg 100% infill with top and bottom layers for strength. Using PETG, this is more than strong enough to hold any reasonable amount of tape.

Supports are needed between the lower slot peg and the upper one.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
285.8 KB
Largest file
143.5 KB

0 comments

See all