
Bộ hứng primer rời cho CH H Reloading Press (Primer Catcher)
- Downloads
- 24
- Likes
- 5
- Views
- 428
- Remixes
- 0
- Comments
- 0
Files 1 16.5 KB
- ch_h_press_primer_catcher_1777701299.stlSTL · 16.5 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #363578
- Category
- DIY
- Published
Description
If you like my models and feel inclined, I could always use more filament for test prints. https://ko-fi.com/plaid_brad
The old CH “H” Reloading Presses are fantastic single stage presses. They're built like tanks and are quite fast and smooth by design. I use one as a dedicated de-capping press with Lee Universal De-capping die. Problem is, there's no included way to collect the spent primers and I would just sweep or vacuum them up from the floor and bench.
This primer catcher will hook-on from the back of the press. If properly printed and installed, a shell holder can be removed or installed with the catcher in place.
Print in the orientation as the model is in the STL. I suggest painting on supports as shown in the 3rd photo, just the horizontal overhangs and the sharp angle of the back. Didn't make a difference with or without support in the hole for the shell holder.
Model shown printed in Polymaker PolyLite PLA Pro.
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 16.5 KB
- Largest file
- 16.5 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-
New -
New -

-


