Thay bản lề Audiotechnica ATH-m50x (Hinge replacement)

Replacement hinge for the audiotechnica m50x. This part has been modeled for the left side, just mirror the part to have the right side. 

To replace this part follow this guide from step 5 to step 13 while skipping step 10, and just reassemble the headphones with the replacement part. Instead of cutting the wires you should desolder them so you can solder them back afterwards.

For best results tune your overhang performance.

Print settings:

• 0.4mm Nozzle

• 0.08mm layer height

• grid supports (Only on buildplate)

• 1 Wall with 100% infill ( To avoid delamination of walls)

• Print out of PETG ideally

• Block support in this area

Submit feature requests here!